Skip to main content

AVTECH cameras: recommended settings

Recommended settings for AVTECH cameras before you connect them to Angelcam.

Written by Ondrej Lanc
  1. Find the camera IP address with the AVTECH IPScan utility.

  2. Log in to the camera admin page, either directly from IPScan or manually from your browser.

  3. Enter the default username and password: admin / admin.

  4. Click Config in the upper right corner.

  5. Go to Network → SNTP. Set the time sync as in the screenshot, use your time zone and click Save.

AVTECH SNTP time sync settings

6. Go to Camera → Video. Adjust Max Bitrate and FPS and click Save.

AVTECH video settings with Max Bitrate and FPS

7. Go to Network → Cloud. If you plan to use the built-in Angelcam Connector, enable Angelcam Cloud and set a video profile. If you plan to use RTSP only, you do not need to switch this on.

AVTECH cloud settings

8. We recommend that you also change the password in General → Account.

9. Reboot the camera.

Your camera is now configured. You can connect it using RTSP or the built-in Angelcam Connector.

Did this answer your question?