Skip to main content

How to manage your Angelcam Connector devices

See your AngelBoxes, AngelCameras and other devices with the Angelcam Connector, connect cameras and speakers, update firmware, or unpair a device.

Written by Ondrej Lanc

The Angelcam Connector tab lists the devices in your location that have the Angelcam Connector built in: AngelBoxes, DIY AngelBoxes, AngelCameras and other devices with the Angelcam Connector.

Here you can see whether a device is online and which cameras and speakers it connects. You can also connect new ones or unpair the device. To learn what the Connector is, see What is the Angelcam Connector and which devices have it?

Open the tab

In the dashboard, open your location and click the Angelcam Connector tab. The tab says Only devices with a built-in Angelcam Connector are shown here. Cameras connected through port forwarding aren't listed.

Angelcam Connector tab with the list of devices

What the device card shows

  • Name, type and ID: for example an AngelBox in Gateway mode with its ID.

  • Online or Offline.

  • Device: the MAC address, the Connector ID (called UUID in older articles) and Connected at, when the device connected. AngelCameras also show the Firmware version and Gateway mode.

  • Streams connected: the cameras that send video through this device. Click a name to open the camera.

  • Speakers connected: the speakers that play through this device.

What you can do

  • Connect camera: find cameras on the device's network and add them. The device must be online.

  • Connect speaker: add a speaker. Only for devices that support speakers, and the device must be online.

  • Update firmware (AngelCamera only): install the latest firmware. The device must be online.

  • Enable gateway mode / Disable gateway mode (AngelCamera only): let the camera connect other cameras on its network too, like an AngelBox.

  • Change location: move the device to another location. Shown only when you have more than one location.

  • Unpair: remove the device from your account. See the next section.

Unpair a device

Unpair a device when you no longer use it or want to move it to another account. Click Unpair. The dialog lists the cameras and speakers connected through the device and marks cameras that have recordings.

Unpair dialog listing connected cameras and speakers
  • Just unpair removes the device. Its cameras stay in your account, but they go offline because their video went through the device.

  • Delete all removes the device together with every camera connected to it, and their sensors. To confirm, type permanently delete. This can't be undone.

In both cases, the device's speakers are deleted, because they only work through the device.

Moving a device to another account? Unpair it here first. Then you can pair it again in the other account.

Did this answer your question?