Skip to main content

How to perform a factory reset on your AngelCamera

Reset your AngelCamera to factory defaults when you switch users or don't know the camera's login credentials.

Written by Ondrej Lanc

Note: AngelCamera One is an older model and is no longer sold. The factory reset works the same way on AngelCamera One, AngelCamera One RTS and AngelCamera Two. The cameras only look slightly different.

AngelCamera user accounts

AngelCamera has no default user account. The camera creates an account during the first connection in the Angelcam mobile app, where you set your preferred username and password.

If a camera already has a user account but you don't know the login credentials, you will likely need to do a factory reset to regain access. A reset is also often needed when the camera switches to a new user.

Find the reset button

The reset button is under a small cover on the side of the camera body.

  • Use a small screwdriver to gently open the cover.

  • Inside, you see the words RESET and Micro SD printed next to their ports.

  • The reset button is clearly labeled and easy to press once the cover is open.

Reset button and Micro SD slot under the side cover of AngelCamera One

Factory reset process

Warning: It is not enough to press the reset button. Follow all the steps below to restore the camera properly.

  1. Power down the camera completely.

  2. Press and hold the reset button.

  3. Power up the camera while you keep holding the reset button.

  4. Keep holding the button for about 15 seconds.

  5. Release the reset button and let the camera restart.

The camera is now reset to its factory defaults. You can set up a new account in the Angelcam mobile app.

If you need further help, contact our support team.

Did this answer your question?