Skip to main content

What is gateway mode in AngelCamera Two?

Gateway mode lets AngelCamera Two work as a camera and as a connector for up to 10 IP cameras or 20 Mbps of total bandwidth on your local network.

Written by Ondrej Lanc

AngelCamera Two includes gateway mode. It lets the camera work both as a camera and as a connector, just like an AngelBox. It supports up to 10 IP cameras or 20 Mbps of total bandwidth on the same local network.

Enable or disable gateway mode during installation

When you install AngelCamera Two, a pop-up window asks you to enable or disable gateway mode.

Pop-up asking to enable or disable gateway mode
  • Enable gateway mode if you want AngelCamera Two to act as a connector for other cameras.

  • Disable gateway mode if you only want to use it as a standalone camera.

The pop-up explains that gateway mode is optional and may affect performance, depending on your local network and internet speed. If performance gets worse, Angelcam recommends that you:

  • Reduce total bandwidth usage.

  • Distribute the load across multiple AngelCameras or AngelBoxes.

  • Lower the bitrate on connected cameras.

Why use gateway mode

Gateway mode removes the need for a separate AngelBox, which saves cost and simplifies setup. It is ideal for:

  • Homes or small businesses with multiple IP cameras

  • Users who want an all-in-one solution

  • Locations without public IP addresses or with dynamic IP issues

An AngelBox remains a good option for larger installations or where you prefer a dedicated gateway.

Did this answer your question?