Skip to main content

Camera with the Angelcam Connector can't be connected: troubleshooting

Fix the connection error or long wait when you connect a camera that has the Angelcam Connector.

Written by Ondrej Lanc

To connect a camera with the Angelcam Connector, the camera needs access to the internet, and you need to finish the pairing within the first 20 minutes after the camera is powered on.

If you get an error when you connect the camera, or wait too long after entering its MAC address, the camera can’t reach Angelcam servers. Try the following:

  1. Make sure the camera has not been powered on for more than 20 minutes. If it has, reboot the camera and try connecting it again. This is a security feature.

  2. Check your upload speed and general connection quality. If the upload speed is too low, set the camera stream to a lower bitrate. See Recommended streaming settings.

  3. Make sure the camera has internet access. When you configure your network, check these points:

    • If you assign the camera a static IP address, fill in the default gateway IP address correctly.

    • Make sure the camera has internet access from the subnet it is in. IP cameras connected directly to an NVR usually don’t have internet access on their own.

    • Configure your firewall so that it doesn’t block access to Angelcam servers.

  4. Set the time in the camera correctly. Preferably, use NTP time synchronization and the correct time zone and DST settings. See How to correct the time on your camera.

If the camera is still paired with someone else's account, see Connecting a camera that is already paired with another Angelcam account.

Did this answer your question?