With event recording, a camera records only when something happens: a sensor sends an event, and the camera records for a short time around it. You may prefer it to recording 24/7 when:
you want to respect the privacy of your employees, neighbors or family,
your upload speed isn’t enough to record all cameras all the time,
your data transfer is limited or paid, for example on a cellular connection.
Event recording uses the camera’s Cloud Recording add-on. There is no separate plan for it: you record less, so you transfer less data and the archive holds only what matters.
What you need
A camera with an active Cloud Recording add-on. See How to activate an account plan.
A sensor that sends events to Angelcam: the camera’s own motion detection, a separate sensor or an alarm panel, by e-mail or the API. See How to send events to Angelcam via e-mail or via HTTP(S).
Set it up
On the dashboard of the location, open the Sensors tab. Click Connect a new sensor, or open an existing sensor and click Edit sensor.
In the Event recording block, set:
Camera: the camera that should record. The list shows whether its Cloud Recording is active.
Enable cloud recording for: how long to record after each event: 30 seconds, 1, 2 or 5 minutes. The recording also includes about 30 seconds before the event.
Record event when disarmed: tick it to record even when the location is disarmed. Leave it off if you don’t want to record anything while you’re at home.
Save the sensor.
The Event recording block of a sensor.
Open the camera’s Timeline and switch Cloud recording to Off. The sensor then turns recording on for the set time after each event. If you leave Cloud recording on, the camera keeps recording all the time.
The Event Recording column in the Sensors list shows which sensors start recording.
Find the recordings
Events appear as marks on the camera’s timeline. Events under the player shows or hides them, and the arrows next to it jump to the previous or next event.
Event marks on the timeline, the Events controls and the Cloud recording switch.
Note: when an event starts the recording, it can take a few seconds before the recording begins. Test your setup to make sure it records what you need.


