Skip to main content

How to connect a camera using port forwarding

Add a camera to MyAngelcam through an open port, and fix the "Internal IP address" and "ports are closed" errors.

Written by Ondrej Lanc

This guide shows how to add a camera to MyAngelcam through port forwarding, and what the error messages mean.

Before you start: the camera’s port must already be open on your router. If it isn’t, follow How to set up port forwarding in your router first. Port forwarding is the hardest and least secure way to connect a camera: an AngelBox, an AngelCamera, or a device with the Angelcam Connector needs no router setup at all.

Connect the camera

  1. In MyAngelcam, click Connect camera. Below the AngelBox and AngelCamera options, under Configure port-forwarding, click Connect.

    Connect camera options in MyAngelcam, with Configure port-forwarding.
  2. Choose Regular IP Camera.

    The Regular IP Camera option.
  3. Choose your camera’s brand. If it isn’t listed, choose H264 or MJPEG camera, of an unknown brand.

    The list of camera brands.
  4. In Enter a network address, enter one of these:

    • your public IP address, for example 203.0.113.25. Click I need assistance below the address field and MyAngelcam shows the public IP address it detected for you.

    • a full stream address, for example rtsp://203.0.113.25:554/stream1. Use it if Angelcam can’t find the stream by itself. See How to find your RTSP stream address.

    • a dynamic DNS hostname, such as myshop.ddns.net, if your public IP address changes from time to time. It is a hostname that always points to your current public IP address.

    The Enter a network address field.
  5. If the camera asks for a login, tick This camera is password protected and enter the camera’s user name and password.

    Angelcam tries the common ports by itself: 80, 81, 88, 554, 555, 6667, 7070, 7447, 8080, 8081, 8090, 8554 and 10554. If you opened a different port, tick Set port manually and enter it.

  6. Click Detect camera.

    The Detect camera button.
  7. When Angelcam finds the stream, you see a preview. Give the camera a name and click Confirm and proceed.

    Naming the camera.

The camera is now connected and you can see it in your dashboard.

The connected camera in the dashboard.

To record or broadcast, the camera needs an add-on. See How to activate an account plan.

Troubleshooting

“Internal IP address”

You entered your camera’s local address, such as 192.168.x.x or 10.x.x.x. Angelcam connects from the internet, so it needs your public IP address or hostname. Find it at whatismyip.com from a computer on the same network as the camera, or click I need assistance below the address field.

The Internal IP address error.

“It seems your ports are closed”

Angelcam couldn’t reach the camera on any port. Click See a list of your ports to see which ports Angelcam tried and which of them are open.

The ports are closed message.
The list of ports Angelcam tried.

If the port you opened shows as closed, the problem is in your router or network. See When the port stays closed. Then enter the address and port in the form and click Check port, or click Try again.

Did this answer your question?