When all the cameras at one site go offline at the same moment, the cameras are usually not the problem. More likely, something they all share has stopped working: the power, the PoE switch, the AngelBox or the internet connection at that site.
Why it's usually not the cameras
Each camera keeps its own connection to Angelcam. If water or a fault damaged a single camera, only that camera would go offline. When every camera at a site drops within the same few seconds, look for the cause in what they have in common.
What to check at the site
Power. Check what the PoE switch or injectors and the router or modem are plugged into. On construction sites and outdoors, this is often a GFCI outlet, a breaker on a temporary panel or an extension cord. They trip when they get wet and stay off until someone resets them. If a long outage ends in the middle of the workday, someone on site probably switched the power back on.
The AngelBox. If your cameras connect through an AngelBox or the Angelcam Connector, they all depend on it. When the AngelBox loses power or its internet connection, every camera behind it goes offline. Check that it has power, that its network cable is plugged in, and that it shows as online in MyAngelcam.
Keep the shared equipment dry. The PoE switch, injectors, power adapters, cable couplers and extension cord connections shouldn't lie on the ground or get rained on. Put them in a weatherproof outdoor box and seal the cable ends.
The internet connection. If the cameras go offline for less than a minute and then come back on their own, the site's connection is probably unstable (for example, an LTE router). Check its signal, its power and whether it's getting wet.
A backup power supply (UPS). Use one for the router, the PoE switch and the AngelBox, so a short power cut doesn't take the whole site offline.
One camera offline on its own?
That's a different problem. See My camera suddenly went offline.
Get notified about outages
Set up camera status monitoring so you know about an outage right away.
Still not sure?
Write to us and tell us how the power and internet are set up at the site. A photo of the setup helps too. We can see in our logs when each camera disconnected, and we'll help you find the cause.
